All Anodized finishes are approximate colors. The anodizing process is electro-chemical and variations do occur across batches. We do not guarantee colors shown on this website will match actual product.
Not many companies offer this but its an excellent way to mount letters indoors where you may later want to remove them for painting the wall or to relocate. With this mount and a mounting pattern, all you do is run drywall screws into the wall, deep enough so their heads protrude, then locate the heads over the large keyhole opening, push toward the wall and pull down to lock in place. No drilling, no glue, and easily removable for painting or moving. Requires fonts large enough and thick enough to accommodate the depth of the keyhole and the
size of its opening. Usually 6" and above and 3/8" or more thick.
High quality, 3M brand Very High Bond double sided tape makes mounting a breeze. Can be used inside or outside on smooth surfaces. Recommended for non porous and sealed surfaces. Metal to metal has strong adhesion.
On thicker letters, 3/8" and 1/2", we can drill and tap the backs of the letters to accept the threaded rods (studs). A mounting pattern is highly recommended to locate the correct places to drill. Once the holes are drilled, screw studs into the stud blocks being careful not to over tighten, then fill the holes with silicon caulk, coat the studs and push the assembly into the wall up to where the stud block meets the wall surface.
Bottom studs are available on 3/8" and 1/2" thick letters over 4" tall. For letters over 8" in height, some form of tie backs will be required to mount this outside. Pleaase check with your local city ordinence before purchasing.