Mount with small spots of silicon adhesive directly to a flat dry surface. This option can be a bit messy and care must be taken to ensure that silicon doesn't squeeze out from the sides. Pinhead amounts should be used, dotted around the back surface in strategic locations. Masking tape will be needed to hold the letters in place while the silicon dries. A good alternative is to use some double stick tape in places that will do the initial holding while the silicon sets.
On thinner letters up to 1/4" thick, we have to weld threaded studs.These studs are not removable without a lot of trouble. Mounting this type of letter requires drilling the wall or mounting surface to accept the metal studs.
On thicker letters, 3/8" and 1/2", we can drill and tap the backs of the letters to accept the threaded rods (studs). A mounting pattern is highly recommended to locate the correct places to drill. Once the holes are drilled, screw studs into the stud blocks being careful not to over tighten, then fill the holes with silicon caulk, coat the studs and push the assembly into the wall up to where the stud block meets the wall surface.
Bottom studs are available on 3/8" and 1/2" thick letters over 4" tall. For letters over 8" in height, some form of tie backs will be required to mount this outside. Pleaase check with your local city ordinence before purchasing.
Similar to a bottom stud, the rail mount includes a length (8ft max) of "C" channel aluminum that tie all your letters together on a single line. Restrictions still apply for tie backs on letters over 8" tall in outdoor use.
Double sets of rails can be used to span spaces or for uneven surfaces such as corrugated buildings. We provide rails and bolts, max. 8ft. Extra costs apply.
1/4" thick, Painted White Aluminum
letters in old english with hawk logo
Polished Stainless Steel
Hot rolled steel after 1 year
Solid Bronze, 3D Bevel cut and polished to a near gold finish
Polished Aluminum custom "D" logo with hand rubbed vine leaf motif.
Red & Black Anodized Aluminum on Satin Aluminum Shield
Oxidized Copper letters for the old florida lumber company
"C" Drawer pulls for a custom executive desk
Cut Metal Letters
Flat cut out metal letters are made from various thicknesses of sheet aluminum, brass, bronze, copper, stainless steel and black steel. Cut with computer driven router systems, we can reproduce all sorts of designs, logo's and virtually any font or custom shape you can think of. We can cut letters as small as 1" high to 30" tall in thicknesses ranging from 1/8" to 1/2".
It doesn't stop there though. All of our letters and logos can be Brushed Satin, polished or painted to meet your specifications and to give you just the look you need for your project or sign.
We can take your .EPS, .CDR or other vector-based art files and produce your letters and logos in just 7 days. Durable enough for outdoors, yet perfect enough for any boardroom application
All of our finished letters are fully protected against weathering with a UV protectant clearcoat so that your sign will look as good after years of service, as it did the day it arrived.
Custom painted colors are also available using PMS matching or using a manufactures color such as Sherwin Williams, PPG, etc.
Custom painted 3/8" aluminum inset for "A" Logo with painted "ALABAMA GOLF" and smaller black painted letters over certificate plaques.